ADYA TelcoNIC FEC Acceleration Card for 5G DU
Overview
The ADYA Telco NIC is built around Xilinx Zynq Ultrascale + MPSoC & RFSoc. It is having two 25G SFP28 and x16 PCIe interfaces bifurcated to two x8 interfaces. This Board is dual slot FHHL (full-height, half-length) form factor. 100G CMAC interface is provided between ZU21DR and ZU19EG for data transfer operations. ADYA Telco NIC has been successfully tested for executing Layer 1 (High PHY & Low PHY) and Fronthaul as the reference solutions.
Key Features
- Xilinx Zynq Ultrascale + ZU21DR
- Xilinx Zynq Ultrascale + ZU19EG
- 2 x QSPI Flash, 256MB in QSPI mode for both SoCs
- Two SFP28 cages for 25G
- x16 PCIe interface bifurcated to two x8 interfaces to the host device through PCIe edge finger connector
- x16 standard NIC card form factor ( 112mm x 168mm )
- JTAG Connectors for Debugging
- DU/CU
- 5G/LTE Base stations
- Data Center Acceleration
- Finance
- Networking
- Security
| Specifications | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| Dimensions | The card is compliant with the PCIe CEM 3.0 specification as a dual-slot, low profile PCIe add-in card.
|
||||||||||
| PCIe Connector/Data-Rates |
|
||||||||||
| DDR4 Specifications |
DDR4 RAM configuration
|
||||||||||
| Network Interfaces | Having two 25G SFP28 and x16 PCIe interfaces bifurcated to two x8 interfaces. | ||||||||||
| USB Maintenance Port | The ADYA card includes a covered micro-USB maintenance port at the I/O bracket. | ||||||||||
| Validated Servers |
|
||||||||||
| Operating System Compatibility |
The following operating systems are supported:
|
||||||||||
| Operating and Storage Temperature Conditions |
|
